Youth:
Age 5-7
Minimum 265lbs
Red restrictor plate
Turf tires
6.5hp 212cc Predator engine
Muffler Required
Stock Flywheel Only.(No Billet or Aluminum Flywheels allowed).

Junior:
Age 8-10
Minimum 290 lbs
Blue Restrictor plate
Turf Tires
6.5hp 212cc Predator engine
Stock Flywheel Only.(No Billet or Aluminum Flywheels allowed).

Senior
Age 11-13
Minimum 320 Lbs
Unrestricted
Open Tire
6.5hp 212cc Predator engine
Stock Flywheel Only.(No Billet or Aluminum Flywheels allowed).
Wings allowed

Driver Safety:
SNELL 85 HELMET REQUIRED (MUST BE FULL FACE), NECK BRACE
REQUIRED,SFI RACE SUIT AND GLOVES REQUIRED AND CLOSED TOED
SHOES REQUIRED. RACE SHOES RECOMMENDED.

Engine:
ONLY the Predator 6.5 HP (212cc) HORIZONTAL SHAFT OVERHEAD VALVE GAS
ENGINE IS ALLOWED! ​Must be purchased from Harbor Freight. The Hemi and
Non-Hemi are both allowed either or.
The governor may be disconnected
The air cleaner can be replaced with any style air cleaner
Carb may not be modified other than jets.

Drive Train:
1. Must be live axle type
2. Must be chain driven
3. Chain Guard must be in place between chain and driver

Clutches:
1. Shoe Type Clutches allowed no disk type clutches.

Frames:
1. Frames and cages must be constructed of metal. No aluminum or conduit tubing.
2. All karts must have a roll cage a minimum four-point either bolted or welded to frame.
3. Minimum of 3″ head clearance to roll cage
4. Minimum four-point seat belts bolted to frame or roll cage.
5. Front and rear bumpers are required. Bumpers must be of tubular design. No flat style allowed.
Maximum width of rear bumper may be no wider than tire sidewall to sidewall width. Maximum width
of front bumper may be no wider than frame rails. Lowest rail of Bumpers may be no higher than 4″
from ground.
6. Nerf bars are required. Nerf bars may not protrude past tire sidewall.
7. All karts must have adequate protection over driver’s feet. Full bodied nose piece recommended.

Exhaust / Header Pipe:
1. May use any type or style of open header.(Youth 5-7) must run Muffler.
2. Must have flared or washer style end. No sharp edges.

Tires & Wheels:
1. Any 5″ or 6″ diameter steel or aluminum wheels.
2. Any compound slick or treaded tire.
3.Turf tires are allowed.

Suspension:
1. No shocks or suspension allowed

Brakes:
1. Mechanical or Hydraulic disc is recommended. No scrubber style brakes. Must stop kart in a safe
distance.
2. Brakes must be in good working order.

Fuel:
Gasoline ​-
1.Pump Gas Only(No additives).
2. No Methanol and No E85

Engine Kill Switches:
1. Must have roll cage mounted on/off switch. Must be mounted in right rear area on roll cage with
the ON position pointing forward or up.
2. Driver must be able to reach a second kill switch while seated and buckled in place.

Weights:
1. All weights added to kart, must be bolted to point of attachment with adequate fastener.
2. All weights must be painted white, so they can be seen if they fall from kart onto track during race.
3. All weights must have kart number on them for identification.

Numbers:
1. Kart number must be displayed on both sides, front, and grandstand side of roll cage.
2. Numbers must be in contrasting color, so scorers can identify kart number.

FINAL NOTES:
THESE RULES ARE NOT ALL INCLUSIVE. SO IF IT DOES NOT SAY YOU
CAN,YOU CAN’T!!
TRACK TECH WILL HAVE THE FINAL SAY ON ALL DISCREPANCIES. ASK
PRIOR TO MODIFYING, BUILDING, OR GUESSING.